Installation And Connection - FONESTAR TSI-40-512 Manual Del Usuario

INSTALLATION AND CONNECTION

1.- Connect the audio sources in the rear of the transmitter and the mains adapter provided. Place the
selector on the rear part of the device in the 0 dB o -20 dB position depending on the type of signal you
have connected to the inputs AF IN (L) and AF IN (R). Place the selector in 0 dB for a line level source
and in -20 dB if a microphone was connected.
2- Position the device on a flat surface or in a 19" rack using the mounts supplied with the device.
INSTRUCTIONS FOR USE
SELECTION OF RF TRANSMISSION/RECEPTION CHANNEL
The transmitter and the receiver (belt pack in-ear monitor) must be tuned into the same channel. Select an
interference-free channel in the receiver and select the same channel in he transmitter. If you wish to use 2
or more transmitter/receiver monitor systems simultaneously observe the indications below to avoid
interference:
- Use radio frequency channels with maximum separation between them. Bear in mind the carrier
frequencies of each channel, as shown in the table below:
CHANNEL FREQUENCY
1
2
3
4
5
6
7
8
9
10
11
- It is possible to use multiple receivers (RI-840-512) with one transmitter on the same channel.
CHANNEL FREQUENCY
512.55 MHz 12
512.95 MHz 13
513.35 MHz 14
513.75 MHz 15
514.15 MHz 16
514.55 MHz 17
514.95 MHz 18
515.35 MHz 19
515.75 MHz 20
516.15 MHz 21
516.55 MHz 22
CHANNEL FREQUENCY
516.95 MHz 23
517.35 MHz 24
517.75 MHz 25
518.15 MHz 26
518.55 MHz 27
518.95 MHz 28
519.35 MHz 29
519.75 MHz 30
520.15 MHz 31
520.55 MHz 32
520.95 MHz
- 3 -
521.35 MHz
521.75 MHz
522.15 MHz
522.55 MHz
522.95 MHz
523.35 MHz
523.75 MHz
524.15 MHz
524.55 MHz
524.95 MHz
EN