Operating Conditions - Chicco CIC03116 Manual De Instrucciones

Trouble
The breast pump does not pump or
pumps very little.
Milk expression is painful.
The breast pump does not switch on.
TECHNICAL SPECIFICATIONS
- 00009199500000 PORTABLE ELECTRIC BREAST PUMP Mod. N0002
- Maximum vacuum level in extraction mode: -0.35 ± 0.03 bar**
(** measured using a sample cylinder).
- Input voltage: 5V 2A
- 3.7V 1100mAh lithium battery
- Appliance service life: 500 hours
- Minimum operating time with battery: 90 minutes
- Type of appliance: intermittent operation; 30 minutes ON - 30 minutes OFF
- Made in China

Operating conditions:

- Operating temperature: +5°C / +40°C
DECLARATION OF EC COMPLIANCE
This Chicco brand Electric Breast Pump appliance
quirements and other provisions indicated in the EU Directives 2014/30/EC (electromagnetic compatibility), 2014/35/EC
(Low Voltage), and 2011/65/EC (RoHS). A copy of the EC declaration can be requested from the manufacturer: Artsana S.p.A
via Saldarini Catelli, 1 - 22070 Grandate (Como) Italy.
THIS PRODUCT COMPLIES WITH THE DIRECTIVE 2012/19/EU.
The crossed bin symbol on the appliance indicates that the product, at the end of its life, must be disposed of
separately from domestic waste, either by taking it to a separate waste disposal site for electric and electronic
appliances or by returning it to your dealer when you buy another similar appliance. The user is responsible for
taking the appliance to a special waste disposal site at the end of its life. If the unwanted appliance is collected
correctly as separate waste, it can be recycled, treated and disposed of ecologically; this avoids a negative impact on both
Cause
Valve not assembled or not properly
assembled.
Cup and motor body not assembly
correctly.
The cup does not fit well on the breast.
Suction level not correctly adjusted.
Low or insufficiently charged battery
Suction level too high.
USB cable/appliance/PC USB port faulty
Incorrect connections.
Low battery.
000091995000000 Mod. N0002 complies with all the essential re-
20
Solution
Assemble the valve correctly.
Check that you have performed
the procedure described in the
"PREPARATION" paragraph correctly.
Make sure that the silicone tube is
firmly connected to both the motor
unit and the membrane cover.
Check that the tube is not damaged.
Do not twist the tube during milk
expression.
Fit the pump body over your breast,
taking care that your nipple is
properly centred. Try with/without
the soft silicone cover.
Change the suction level until
you achieve more comfortable
stimulation and suction by pressing
the "+" or "-" buttons.
Charge the battery
Change the suction level until
you achieve more comfortable
stimulation and suction by pressing
the "-" button.
Check that mains power is present
in the PC
Check all the connections.
Charge the battery