GYS MONOGYS 160-2S Manual De Instrucciones página 12

"SYNerGiC" MOde (fiG 5)
This function automatically controls the wire speed. There is no need to set the wire speed manually.
Position the wire speed potentiometer (3) in the middle of the« Optimal synergic » zone.
- Select:
- Wire type (1)
- Wire diameter (2)
- Power mode (4 position switch)
To select the right position in accordance with the thickness of the workpiece, please refer to the "synergic mode"
table on the previous page.
From the combination, the Monogys 185-2S determines the optimal wire speed and the device is ready to weld. It is
also possible to adjust the wire speed if necessary by adjusting the potentiometer + or – manually (3).
The last welding configuration is saved in the memory automatically
GAS (for steel welding) :
In synergic mode, the Monogys 160-2S and 200-2CS determine the welding settings in accordance with
the gas used. By default, in steel welding the machine is set to « Argon + CO2 ».
To change the gas and set the machine to C02 mode or go back to Argon + CO2 mode :
1- Press « Type » for 5 seconds until the panel switches off, then release.
2- After 5 seconds, choose the required setting using the « mode » button.
Normal (2T) => Argon + CO2 (default setting)
Delay => CO2 100%
3- Confirm selection by pressing the « Type » button, or waiting 5 seconds.
4- Once confirmed, the machine reverts to the normal operating mode but the gas mode chosen will stay
selected, even when the machine is switched off.
dutY CYCle & WeldiNG eNvirONMeNt iN uSe
- The welding unit describes an output characteristic of "constant current" type. The duty cycles following the stan-
dard EN60974-1 (at 40°C on a 10mn cycle) are indicated in the following table:
X/60974-
1 à 40°C(T
cycle=10min)
Monogys 160-2S 15% à 140A
Monogys 200-2CS 15% à 190A
Monogys 250-4CS 15% à 250A
Note: The machines' duty cycle has been tested at room temperature (40°C) and has been determined by
simulation.
- This is a A-class device. It is designed to be used in an industrial or professional environment. In a different environ-
ment, it can be difficult to ensure electromagnetic compatibility, due to conducted disturbances as well as radiation.
This device complies with IEC 61000-3-12.
adviCe & therMal prOteCtiON
- Always respect the basic rules of welding.
- Do not block/cover the ventilation holes of the machine.
- Leave the device plugged in after welding to allow it to cool.
- Thermal protection: If the machine becomes too hot, the warning light will illuminate and the machine will stop.
The cooling time will be a few minutes; length of time will also depend on the external temperature.
All manuals and user guides at all-guides.com
MONOGYS 160-2S / 200-2CS / 250-4CS
I max 60%(T cycle=10min)
70A
110A
170A
100%(T cycle=10min)
55A
90A
110A
eN
sous 230V
sous 230V
sous 240V
12