3. Insert a wall anchor (included) in each hole,
ensuring the plug is flush with the wall surface.
(See Figure 3)
NOTE: This step may require a light tap with
hammer.
Figure 3
4. Place the wall-mounted unit over the screw holes
and screw unit to wall using the screws supplied.
(See Figure 4)
Figure 4
5. Attach the top and bottom caps to the
wall-mounted unit. (See Figure 5)
Figure 5
PAGE 2 OF 9
INSTALLATION CONTINUED
Top Cap
Caps Attached
Bottom Cap
6. Clip the wall receiver to the belt end and extend the
belt to the opposite wall. (See Figure 6)
7.
Use a pencil to mark the required location for wall
receiver's screw holes. (See Figure 7)
Figure 7
8. Using a 17/64" drill bit, drill two holes in the positions
marked. (See Figure 8)
Figure 8
Figure 6
Wall
Receiver
0422 IH-5098