Packing List - Ryobi RY40702 Manual Del Operador

PACKING LIST

Tiller
Left TIne Assembly
Right TIne Assembly
Hitch Clip (2)
Shear Pin (2)
Upper Handle w/Hardware
Wheel (2)
Lock Pin (2)
Dirt Flap w/Hardware
Bull Bar w/Hardware
Ballast Tank w/Hardware
Upper and Lower Side Panels w/Hardware
Depth Bar w/Hardware
2-Sided Wrench
Hex Key (3 and 6 mm)
T-25 Torx Wrench
Quick Reference Guide
Operator's Manual
WARNING:
If any parts are damaged or missing, do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the start key and battery
packs from the product when assembling parts.
ASSEMBLY
NOTICE:
Do not allow the cables connecting the control panel and
motor to become pinched or trapped during assembly.
INSTALLING THE UPPER HANDLE
See Figures 2 - 3.
 Rotate the lower handle until it rests on the tine shield,
then slide the upper handle into the lower handle.
NOTE: The upper handle should fit inside the grooves in
the lower handle.
 Align the holes in the lower handle with the holes in the
upper handle, and secure using bolts, washers and nuts.
Tighten securely.
 Secure the two wire harness connectors of the wire
assembly by screwing the terminals together until thumb
tight with the integrated nut on the motor connector.
INSTALLING THE BULL BAR
See Figure 4.
 Place the bull bar on the front of the tool.
 Align the holes in the bull bar's bracket with the threaded
holes at the front of the tool.
 Install bolts and washers through the holes. Tighten
securely with the hex key provided.
INSTALLING THE BALLAST TANK
See Figure 5.
 Carefully remove the cover from the ballast tank.
 Remove the bolts and wing nuts from the ballast tank.
 Place the ballast tank on the bull bar.
 Algin the holes in the ballast tank with the holes in the
bull bar.
 Insert bolts through the holes and install wing nuts.
Tighten securely.
 Reinstall tank cover.
INSTALLING THE WHEELS
See Figure 6.
Wheels are provided to assist in moving the unit to and from
the work area. To install:
 Slide a wheel onto the axle.
WARNING:
Ensure the wheels are installed for self-propulsion during
normal operation. Doing so will ensure the wheels provide
adequate resistance to the force generated during
tine rotation. If the wheels are installed in the wrong
position, the tine rotation could cause the unit to move
unexpectedly which could result in property damage or
serious personal injury.
7 — English