Belt Adjustment; Safety Check - Bodypoint Evoflex EB205 Instrucciones De Instalación

EVOFLEX BELT EXTENDER INSTALLATION (OPTIONAL)
Attach Belt Extender to Evoflex. Spring washer not used.
To prohibit belt rotation.
(Pin facing in)
MOUNTING
Attach Belt Extender with
Evoflex to wheelchair
using one of the methods
shown under Mounting
Options. (Spring washer
optional.)

BELT ADJUSTMENT

When the belt is properly adjusted and tightened, it should fit
snugly, with all slack removed, so that the user is secure. Use the
pull strap for daily adjustments, such as to accommodate changes
in clothing. If additional length adjustment is necessary to achieve
a good fit or to remove the product for cleaning, this can be done
at the end straps.

SAFETY CHECK

When properly positioned in wheelchair, have user lean forward
and side to side to check fit. Check for:
1. Normal operation of buckle and adjustment straps.
2. Comfort: Look for areas of irritation.
3. Position: If too high or too low, adjust anchor points.
4. Interference with other devices: Relocate anchor points as
necessary.
5. Move chair through full range of motion, including tilt, folding,
and rolling. Check for any interference and relocate mounting
points as necessary.
Apply
threadlocker
Cut to length as needed
using a saw. Ensure cut
location is as far away as
possible from mounting
hole being used.
4mm (5/32")
To allow belt rotation. (Pin facing out)
en