S-Video & Component Video - CyberHome DVR 1600 Manual

S-Video & Component Video Connections
S-VIDEO is a higher quality connection than standard composite video, and requires a special S-Video cable (not
included). The S-Video connector is distinguishable by its 4 pins, as shown below. If your TV has an S-Video input,
it's recommended that you use this type of connection for better picture quality.
1
First, obtain a special S-Video cable. Connect the
S-Video output from the unit to the corresponding
input on your TV.
2
On your TV, select the S-Video input. This is
normally done by selecting "Video 2" or "AV2" with
the remote control. On some TVs, this is done by
selecting a particular channel.
The Recorder
1 You can enjoy high quality picture reproduction by
using the component video output instead of S-Video
or Composite video output. Connect the cables per
the illustration.
On your TV, select the component or
2
progressive scan input. This is
normally done by selecting "Video 2"
or "AV2" with the remote control. On
some TVs, this is done by selecting a
particular channel.
3
Change the Setup Menu/A/V
Output/Scan Mode to Progressive if
your TV supports P-SCAN or
Interlace if it supports component.
All manuals and user guides at all-guides.com
10
S-VIDEO CABLE
( NOT INCLUDED )
COMPONENT VIDEO CABLE
( NOT INCLUDED )
GREEN GREEN
The Recorder
Connections
RED RED
BLUE BLUE