Dometic MPC 01 Plus Instrucciones De Montaje Y De Uso página 18

Connecting and installing the system
Connecting the step button
➤ Connect the step button (fig. 1 8, page 3) and extension cable to the associated input
(fig. 4 7, page 5).
➤ Connect the step to output E1.
➤ Connect the tent light to output E17.
No. in
fig. 5,
page 6
1
2
3
Connecting the MPC01 Plus to the voltage supply
I
NOTE
The cables for connecting the batteries are not included in the scope of delivery.
Select a cable cross section suitable for the maximum currents.
Connecting the consumer unit battery:
➤ Connect the positive terminal of the consumer unit battery to "Battery II" using a cable with a
ring cable lug.
➤ Connect the negative terminal of the consumer unit battery to "Earth" using a cable with a ring
cable lug.
Connecting the starter battery:
➤ Connect the positive terminal of the starter battery to "Battery I" using a cable with a ring cable
lug.
➤ Connect the negative terminal of the starter battery to "Earth" using a cable with a ring cable
lug.
Connecting power consuming devices to the battery sensor
➤ Always connect the negative pole of the power consuming devices to the correct connection
on the battery sensor (fig. 6 1, page 6).
Connecting the base vehicle
➤ Connect the D+ signal of the base vehicle and the side lights to the connection (fig. 4 15,
page 5) using the D+ cable (fig. 1 12, page 3). For this, cut through the centre of the D+
cable (fig. 1 12, page 3) supplied and connect the corresponding voltages and signals.
18
Symbol Description
Retract step
Extend step
Switch tent light on/off
MPC01 Plus
EN