Replacing Carbon Brushes - Makita JS1600 Manual De Instrucciones

Ocultar thumbs Ver también para JS1600:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Mild steel (thickness)
1.6 mm (16 ga)
Max. cutting width (A)
100 mm (4")
Stainless (thickness)
1.2 mm (18 ga)
Max. cutting width (A)
80 mm (3-1/8")
006429
Minimum cutting radius
Minimum cutting radius is 30 mm (1-3/16") when cutting
1.0 mm (20 ga.) mild steel.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may
result.

Replacing carbon brushes

1
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
1
2
004705
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
All manuals and user guides at all-guides.com
ACCESSORIES
Under 1.2 mm (18 ga)
No limit
Under 1.0 mm (20 ga)
No limit
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
MAKITA LIMITED ONE YEAR WARRANTY
Warranty Policy
Every Makita tool is thoroughly inspected and tested
before leaving the factory. It is warranted to be free of
defects from workmanship and materials for the period
of ONE YEAR from the date of original purchase.
1. Limit mark
Should any trouble develop during this one year period,
return the COMPLETE tool, freight prepaid, to one of
Makita's Factory or Authorized Service Centers. If
inspection shows the trouble is caused by defective
workmanship or material, Makita will repair (or at our
option, replace) without charge.
This Warranty does not apply where:
IN NO EVENT SHALL MAKITA BE LIABLE FOR ANY
INDIRECT, INCIDENTAL OR CONSEQUENTIAL
DAMAGES FROM THE SALE OR USE OF THE
PRODUCT. THIS DISCLAIMER APPLIES BOTH
DURING AND AFTER
1. Screwdriver
WARRANTY.
2. Brush holder
MAKITA DISCLAIMS LIABILITY FOR ANY IMPLIED
cap
WARRANTIES, INCLUDING IMPLIED WARRANTIES
OF "MERCHANTABILITY" AND "FITNESS FOR A
SPECIFIC PURPOSE," AFTER THE ONE YEAR TERM
OF THIS WARRANTY.
This Warranty gives you specific legal rights, and you
may also have other rights which vary from state to
state. Some states do not allow the exclusion or
limitation of incidental or consequential damages, so
the above limitation or exclusion may not apply to you.
Some states do not allow limitation on how long an
implied warranty lasts, so the above limitation may not
apply to you.
EN0006-1
6
CAUTION:
These
accessories
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
Blades
Hex wrench
repairs have been made or attempted by others:
repairs are required because of normal wear and
tear:
the tool has been abused, misused or improperly
maintained:
alterations have been made to the tool.
or
attachments
are
Only use
accessory or
THE
TERM
OF
THIS

Publicidad

Tabla de contenido
loading

Tabla de contenido