Safety Warnings For Cordless Impact Screwdriver; Battery And Charger - Truper MAX-20D Manual

Safety warnings for
Cordless Impact Screwdriver

Battery and Charger

DANGER
• Use only Truper Max chargers to charge
the battery. Using a different charger may cause fire or
injury hazard.
• Use only batteries specifically designed
DANGER
for the tool. Different batteries could generate risk of injury
or fire.
DANGER • Do not use the charger outdoors.
• When charging, obey the "+/-" polarity.
• Never recharge a leaking battery or that is visibly
damaged.
• Do not use batteries or a charger for purposes different
that it was designed for.
• Do not modify the battery contacts or the chargers.
• Never expose the batteries to higher than 122 °F
temperatures or direct sun light.
DANGER • Never expose the batteries to fire or
impact. They could explode.
CAUTION • Batteries shall be kept away from
metallic objects like clips, coins, keys, nails, screws or other
type of object making contact with the terminals. It would
cause a short circuit and burns or fire. They should be kept
clean, dry and in good repair.
CAUTION • Under extreme conditions the battery
liquid could spill out. Avoid any contact. If an accidental
contact happens clean with enough water. If the battery
liquid comes into contact with your eyes, clean with
enough water and immediately go see the doctor. Liquid
expelled from the batteries could cause irritation or burns.
• Remove battery when not in use.
CAUTION • If the battery will be stored for long
periods of time, keep an intermediate charge (40%) to
maximize its useful life. Do not leave it completely charged
for long periods of time, or leave it charging when not in
use.
• Keep batteries away from children reach.
• Do not discard batteries together with household trash.
Go to a specialized center for it's recycling.
Select the Adequate Bit
CAUTION • Use only screwdriver bits
recommended by
• Keep the screwdriver bits in good repair. This measure
reduced the load onto the tool and extends the tool useful
life.
When Operating the Screwdriver
CAUTION • This tool is designed to work with
screws. IT IS NOT A DRILL.
• This is a light-work tool. It shall not be used to remove or
set screws requiring a high torque.
• Do not try to modify the tool or the accessories in no
way.
• Turn ON the screwdriver after setting the bits.
• Use extreme care when screwing screws with grove head.
The tool may slide away.
• Do not use too much force.
• Do not use this tool single-handedly.
• After each use remove the bit and the extensions. Store
them properly.
WARNING Danger of asphyxiation!
Children may swallow small parts and choke.
Keep children away from small parts
.
Hold the power tool by the insulated gripping
parts when carrying out operations where the
fastener may get into contact with hidden cables
or its own power cable.
Fasteners making contact with a power cable may turn
"alive" the metal parts of the tool and as consequence,
cause an electric shock to the operator.
• Wear hearing protectors when making jobs
with a noise level higher than 85 dB.
• Wear anti-dust mask and dust extraction equipment if
necessary. Remember that working with materials like
asbestos, leaded paint, additives, some types of wood,
metals or minerals are highly toxic.
• Wear safety eyeglasses.
.
ENGLISH 5