Xiaomi Mi Robot Vacuum-Mop 2 PRO white Manual De Instrucciones página 16

3. Remove the filter, and use the cleaning tool to clean the dust
compartment and the filter, and then wash them with clean water. Install
the dust compartment and the filter back a er fully drying them.
Note: It is recommended to thoroughly clean the dust compartment at least once a
week. Make sure to fully dry the dust compartment and the filter before use (at least
dry them for 24 hours).
Water Tank
Simultaneously press and hold both the release bu ons of the water tank,
and then slide it out from the bo om of the vacuum-mop as illustrated.
Note: A er mopping, immediately remove the water tank, empty out any remaining
water, and clean and dry the mop pad to prevent lingering odor and mildew.
Water Tank Release Bu on
Brush
1. Flip the vacuum-mop over and press and hold the two release bu ons to
remove the brush cover.
2. Remove the brush upwards.
3. Pull out the brush bushing.
4. Rotate the brush holders until the alignment mark on each holder is
aligned with the unlocking mark, and then remove the brush holders from
both ends of the brush.
5. Use the blade of the cleaning tool to cut the hair tangled on the brush
and thoroughly clean the brush.
6. Reinstall the brush holders and the brush bushing.
7. Reinstall the brush and the brush cover, and press the brush cover
securely into place.
Locking Mark
Alignment Mark
Unlocking Mark
14
Brush Cover
Locking Mark
Release Bu on
Brush
Brush Bushing
Alignment Mark
Brush Holders
Unlocking Mark