All manuals and user guides at all-guides.com
■ Technical Specifications
Drivers
System Design
Smooth operating frequency range
Sensitivity
Impedance
Maximum SPL
Power Handling
Crossover
Input
Cabinet Material
Cabinet Finish
Grille
Rigging Attachment Points
Height x width x depth
Weight
Accessories
■ Optional Accessories
None accessories are designed for the IS SUB 215
■ EC Declaration of Conformity
This equipment is in compliance with the essential requirements and other relevant provisions of Directives
2004/ 108/ EG and 2006/ 95/ EG. The declaration is available on the internet site at www.klein-hummel.com.
Before putting the device into operation, please observe any respective country-specific regulations.
■ Recycling
Attention to product quality in the design phase ensures, firstly, that products have a long life and that, secondly,
all parts of a product may be reused or recycled at the end of that life. An extensive product servicing network
ensures that products can be repaired in the event of the premature failure of a part, or as a way to prolong the life
of a product that would otherwise be considered a candidate for landfill. Eventually there comes a time when a
product is considered beyond repair (for economic reasons or lack of parts), so the parts must be disposed of in a
suitable manner. The disposal should conform to local environmental regulations and be conducted in an
authorized recycling facility. This product consists of some or all of these components:
Item
Material
Loudspeaker
Steel, Plastic, Copper, Wool, Wood,
Electronic devices
Packing Material
Cardboard, wood and/or plastics
User Manual
Paper and cardboard
Operating Manual IS SUB 215
2 x 15" long excursion woofer, water resistant coating
Direct radiated, bass reflex
38 Hz – 200 Hz +/- 3 dB
98.0 dB SPL, 1 Watt, 1 meter
4 Ohms (2 x 8 Ohm drivers in parallel)
134.0 dB SPL, peak, 180 ms sine-wave burst
2000 Watts, 7000 peak (10 ms)
None
2 x Speakon NL4, Input and Through
Terminal 2 ± to subwoofer drivers
Terminal 1 ± pass through only
18 mm Birch plywood
Black structured lacquer (RAL 9005), white option (RAL 9010)
Powder coated steel Grille, foam backing
(16) M10 thread points
430 x 827 x 725 mm (17 x 32.5 x 28.5 inches)
64 kg (141 lbs)
None
Recycling Instructions
Recycling only in authorized recycling plants
Separate materials then recycle
Recycle
English
Klein + Hummel
IS SUB 215
4