2610067140 3Z Laser Measurer 02-21.qxp_Layout 1 2/24/21 8:01 AM Page 1
use. Other persons could be blinded by the laser beam.
Protect the laser measure against moisture and direct sun light.
Do not subject the laser measure to extreme temperatures or varia-
tions in temperature. As an example, do not leave it in vehicles for a long
time. In case of large variations in temperature, allow the laser measure to
adjust to the ambient temperature before putting it into operation. In case
of extreme temperatures or variations in temperature, the accuracy of the
laser measure can be impaired.
Avoid heavy impact to or falling down of the laser measure. After severe
exterior effects to the laser measure, it is recommended to carry out an ac-
curacy check (see "Accuracy Check of the Distance Measurement", page
15) each time before continuing to work.
Switching the Laser Measure on/off
– To switch on the measuring tool, briefly press the measuring button (1).
When the measuring tool is switched on, the laser beam is switched on.
The indicator (d) flashes on the display.
– To switch off the measuring tool, hold down the measuring button (1).
self, not even from a large distance.
Measuring Process
A continuous measurement is performed after the measuring tool has been
switched on. The current measured value (a) is shown on the bottom line
of the display (see figure 2).
12
Operation - Laser Measure
Do not leave the switched-on laser measure un-
attended and switch the laser measure off after
Do not point the laser beam at persons or ani-
mals and do not look into the laser beam your-