Dremel 3Z Instrucciones De Funcionamiento Y Seguridad página 16

2610067140 3Z Laser Measurer 02-21.qxp_Layout 1 2/24/21 8:01 AM Page 1
– Switch on the measuring tool (see "Switching the laser measure on/off",
page 12).
Only use the tape adapter on clean and dust-free surfaces to avoid
measurement inaccuracies.
Measuring length (see figures 6−7)
After the measuring tool has been switched on, the tape extension is meas-
ured continuously. The current measured value (a) is shown on the bottom
line of the display. During continuous measurement, the length of the tape
can be adjusted, and the current measured value (a) is updated on the bot-
tom line of the display.
The measuring process is indicated by a blinking arrow on the display.
There are two possibilities to measure distances: using the outer edge or
using the hook function (inner edge) for measurements.
Outer edge measurement:
– Pull the tape (10) out of the adapter by the contact edge (11) and place
the tape with the outer edge (12) (marked in blue) against the object to
be measured (Fig. 6).
Fig. 6
The visible length of tape (between the blue marking on the outer edge
of the contact edge and the marking on the exit of the tape on the
adapter housing) corresponds to the measurement length (in inch).
16
Operation - Tape Adapter
''