9&1 70051 Instrucciones De Uso página 20

Wipe the drill using a well-wrung cloth after use and always keep the surface and ventilation holes free of dirt.
Never use corrosive or abrasive detergents, as they may attack the plastic parts of the machine.
Replacing carbon brushes
CAUTION!
Always be sure that the tool is switched off and unplugged before attempting to perform
inspection or maintenance.
Inspecting the mounting screws regularly inspect all mounting screws and ensure that they are properly tightened.
Regularly clean the tool's air vents with compressed dry air. Do not attempt to clean by inserting pointed objects through
openings.
For safety reasons, the machine automatically switches off if the carbon brushes are so worn out that they no longer
have contact with the motor. In that case, the carbon brushes must be replaced by a pair similar carbon brush available
through the after-sales service organization or qualified professional person.
CAUTION: The brushes must always be replaced in pairs.
CAUTION: Always disconnect the machine from the power supply before removing any electrical
covers.
Recycling
Meaning of crossed –out wheeled dustbin:
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities.
Contact you local government for information regarding the collection systems available. If electrical
appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater
and get into the food chain, damaging your health and well-being.
When replacing old appliances with new ones, the retailer is legally obligated to take back
your old appliance for disposals at least free of charge.
Values measured in accordance with EN 60 745-2-1 and EN 60 745-1.
Warning: the level of actual vibration emission during use of the machine may differ from that specified in the user's
manual or by the manufacturer. This may be due to the following factors that must be considered before or during use:
- If the device is used correctly.
- Correct the tip of the material to be processed.
- This is the condition of use of the device in order
- If the grip handles are equipped with optional vibration handles, they will be firmly attached to the body of the
machine