Troubleshooting Guide - aarke CARBONATOR 3 Guia Del Usuario

EN
User Guide

TROUBLESHOOTING GUIDE

Problem
1. When I push the
lever, very little or no
gas comes out.
2. Gas is flowing
into the bottle when
I push the lever, but
the water isn't getting
carbonated.
3. I hear a leaking sound
when I push the lever
and very little gas is
flowing into the bottle.
4. There are drops
of water inside the
cylinder compartment
5. I can hear gas
leaking out when
screwing in the gas
cylinder, even though
I'm not pushing down
the lever.
6. The cylinder is
freezing inside the
Aarke Carbonator
during use.
Suggested solutions
- Check if the gas cylinder is empty.
Check if the gas cylinder is screwed in tightly enough (some
-
older gas cylinders need a little extra tightening).
- Make sure you're pushing the lever all the way down (without
forcing it).
- Listen for a leaking sound when you push the lever – if you do,
refer to problem #3.
- If these solutions don't work, contact us via aarke.com/contact
and let us know what's happening.
- There may be an issue with the cylinder gasket. Refer to the next
page for further gasket-related instructions.
- Make sure you're holding the lever down until you hear a
buzzing noise from the valve, then release. Be sure not to
release until you hear the buzzing noise! If this doesn't solve
your problem, please contact us via aarke.com/contact and let
us know what's happening.
- Check if the gas cylinder is screwed in tightly enough.
- There may be an issue with the cylinder gasket. Refer to the next
page for further gasket-related instructions.
- Check if the gas cylinder is screwed in tightly enough.
- Make sure to hold down the lever for about 3-4 seconds until you
hear the buzzing noise when carbonating. Release the lever slowly.
- There may be an issue with the cylinder gasket. Refer to the next
page for further gasket-related instructions.
- There may be an issue with the cylinder gasket. Refer to the next
page for further gasket-related instructions.
- This may be due to a leak between the gas cylinder and the
Aarke Carbonator. Try screwing the gas cylinder in a bit tighter.
- There may be an issue with the cylinder gasket. Refer to the next
page for further gasket-related instructions.
8
EN