Makita AN911H Manual De Instrucciones página 6

Clavadora para construcción
Ocultar thumbs Ver también para AN911H:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Lift and turn the coil support plate so that the arrow with
nail size indicated on the coil support plate will point to
the corresponding graduation increment marked on the
magazine. If the tool is operated with the coil support
plate set to the wrong step, poor nail feed or malfunction
of the tool may result.
3
009467
Place the nail coil over the coil support plate. Uncoil
enough nails to reach the nail guide. Place the first nail
in the feeder and the second nail in the feed claw. Place
other uncoiled nails on feeder body. Close the magazine
cap slowly until it lock after checking to see that the nail
coil is set properly in the magazine.
1
2
3
009468
Connecting air hose
Slip the air socket of the air hose onto the air fitting on
the nailer. Be sure that the air socket locks firmly into
position when installed onto the air fitting. A hose
coupling must be installed on or near the tool in such a
way that the pressure reservoir will discharge at the
time the air supply coupling is disconnected.
1. Adjustfit
1
2. Change plate
3. Arrow
2
1. Door
2. Feed claw
3. Driver channel
OPERATION
CAUTION:
Make sure all safety systems are in working order
before operation.
1.
To drive a nail, you may place the contact element
against the workpiece and pull the trigger, or
1
2
009463
3
009464
2.
Pull the trigger first and then place the contact
element against the workpiece.
No. (1) method is for intermittent nailing, when you
wish to drive a nail carefully and very accurately.
No. (2) method is for continuous nailing.
CAUTION:
However when the tool is set to the "Intermittent
Nailing" mode, WITH THE TRIGGER HELD IN A
HALF-PULLED POSITION, an unexpected nailing
could occur, if contact element is allowed to re-
contact against the workpiece or the other surface
under the influence of recoil.
In order to avoid this unexpected nailing, perform
as follows;
A. Do not place the contact element against the
workpiece with excessive force.
B.
Pull the trigger fully and hold it on for 1-2
seconds after nailing.
For No. (1) method, set the change lever to
the
position.
For No. (2) method, set the change lever to
the
position.
After using the change lever to change the nailing
method, always make sure that the change lever
is properly set to the position for the desired
nailing method.
6
1. Trigger
2. Contact element
1. Trigger
1
2. Workpiece
3. Contact
element
2

Publicidad

Tabla de contenido
loading

Tabla de contenido