Waeco PerfectView RV-FM-10 Instrucciones De Montaje página 25

_RV-FM-10.book Seite 25 Mittwoch, 11. Januar 2006 11:03 11
All manuals and user guides at all-guides.com
PerfectView
➤ Screw the module on with M5 x 20 mm self-tapping screws.
➤ Screw the antennas into the antenna connections on the modules.
➤ Check that the receiver module is set to the same channel as
the transmitter.
6.3 Connecting the transmitter module
General notes on laying cables
Note
As far as possible use original ducts or other alternative ducts for
the connection cable duct, e.g. the paneling edges, ventilation gril-
les or blank panels. If no ducts are available, you will need to drill
holes for the cables. Check beforehand that there is sufficient room
for the drill head to emerge once the hole has been made.
Note
Cables and connections which are not installed properly will cause
malfunctions or damage to components. Correct installation of ca-
bles and connections is the basic prerequisite for a lasting and
trouble-free operation of the retrofitted components.
Please observe the following instructions:
Wherever possible lay cables inside the vehicle, as they are better protec-
ted inside than outside the vehicle.
If you do need to lay a cable outside the vehicle, ensure that it is well se-
cured (use additional cable binders, insulating tape, etc.).
To prevent damage to the cables, when laying them ensure that there is
sufficient distance to hot or moving vehicle components (exhaust pipes,
drive shafts, light systems, fans, heater etc.).
Wrap insulating tape around every connection on the cable (even inside
the vehicle) (fig. 8, page 4).
When laying cables, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection (fig. 3,
page 3)
Installing the radio link
25