Refsta AMPERLINK Manual De Utilización página 23

TROUBLESHOOTING GUIDE – FAQ
Read and follow the instructions in the "instructions for use" section. Check that there are no interruptions
in the power supply.
Dry the surface well before pressing the keys or performing other maneuvers.
If you cannot turn off the appliance, after using it, disconnect it from the power supply. •
ERROR TYPE
Amperlink
doesn't work
Amperlink
doesn't work
Amperlink
doesn't work
Amperlink
doesn't work
Amperlink
doesn't work
HELPDESK
Before calling the Customer Service:
1) Check whether it is not possible to eliminate the
faults yourself (see "Troubleshooting guide").
2) Switch the appliance off and on again to make sure
that the problem ir resolved.
If, after the above checks, the problem persists, contact
the nearest After-sales Service. Always indicate:
- A brief description of the fault;
- The exact type and model of the product;
- Your full address;
- Your phone number.
If a repair is necessary, contact a service center (to
guarantee the use of original spare parts and correct
replacement). Spare parts are available for 10 years.
DESCRIPTION
The remote control
doesn't work
RF Connection
The hood switches on
automatically
The hood works by
default even if I have
disconnected the
function
I changed the state
of the hood from the
button panel
POSSIBLE
CAUSES
Press the AMPERLINK P1 button for 3
New remote seconds, and within 10 seconds, press a
control or with button on the remote control. If the pairing
different code procedure was successful, it will generate
along beep.
Excessive distance Press and release the AMPERLINK P1
or shielding of key a few times, if the RF connection is
radio waves established, the hood light will turn on
and off.
With the hood off, hold the minus button
Amperlink not on the remote control for a few seconds.
active 3 short beeps signal the activation of the
AMPERLINK function.
To deactivate the AMPERLINK function, just
Function not press any button on the remote control. A
disconnected long beep signals the deactivation of the
AMPERLINK function.
The hood will change state based on the
button pressed, the AMPERLINK function
Local Functioning remains active and will transmit the
appropriate suction speed, the next time the
hob switches state/threshold.
DISPOSAL
The symbol on the product or the accompanying
documentation indicates that this product must
not be treated as household waste but has to be
delivered to the appropriate collection point for
the recycling of electrical and electronic equipment.
Discard them according to local regulations for
waste disposal. For further information on the
treatment, recovery, and recycling of this product,
contact the appropriate regional office, the
household waste collection service or the shop
where the product was purchased.
IT'S DECLINED ANY LIABILITY FOR ANY DAMAGES
CAUSED BY FAILURE TO COMPLY WITH THE
ABOVE WARNINGS
- 23 -
SOLUTION