VONROC TC501AC Traducción Del Manual Original página 10

EN
4. OPERATION
Before starting the job, please ensure there
is sufficient water in the water reservoir
(24) i.e. the diamond blade must runs
through the water. During the job, the water
reservoir must be topped up.
Do not start working before the maximum
speed has been reached.
The diamond blade must NEVER be
exposed to sideways pressure; they can
break and the flying pieces become
projectiles!
Always keep the mains cable away from
moving parts.
Switching on/off (Fig. A)
• Press the switch (1) into position '1' to put your
machine into operation.
• To switch off the machine the same switch (1)
needs to be pressed to position '0'
Straight cuts (Fig.A & J)
The parallel guide (13) enables you to cut parallel
to the cutting blade and make straight cuts.
1. Loose the knob (14) and set the required dis-
tance.
2. Tighten the knob (14).
3. Position the tile on the table top.
4. Press the switch (1) into position '1' to put your
machine into operation.
5. Maintain an even pressure, hold the tile against
the cutting guide and push steadily through the
cutting wheel.
6. When the cut is complete, you can switch (1)
off the machine.
Mitre cut (Fig. A & K)
Mitre 0-45° cuts can be made using the mitre
guide (12).
1. Slide the mitre guide (12) into place on the
parallel guide (13).
2. Loose the knob (11) and set the required angle.
3. Tighten the knob (11).
4. Position the tile within the jaws of the mitre
guide (12).
10
5. Press the switch (1) into position '1' to put your
machine into operation.
6. Push the mitre guide (12) steadily along the
parallel guide (13), feeding the tile through the
cutting wheel (7).
7. When the cut is complete, you can switch (1)
off the machine.
Bevel cut (Fig. A & L)
Beveled 22.5° and 45° cuts can be made by adjus-
ting the angle of the bevel table (3).
1. Pull the bevel table handle (5).
2. Raise the bevel table (3) to the required angle,
as shown on figure L1.
Make sure bevel table is locked firmly in
place before beginning cut.
3. Position the tile on the bevel table (3), as shown
on figure L2.
4. Press the switch (1) into position '1' to put your
machine into operation.
5. Maintain an even pressure, hold the tile against
the cutting guide and push steadily through the
cutting wheel (7).
6. When the cut is complete, you can switch (1)
off the machine.
Transporting the tile cutter (Fig. A & I)
Before transporting the tile cutter, the following
steps must be carried out:
1. Pull the mains plug.
2. Remove all accessories that cannot be mounted
firmly to the power tool.
3. Wind the mains cable and bind it.
4. Remove bevel table (3).
5. Put the tile saw on a bucket.
6. Remove overflow drain (22).
7. Empty the reservoir (24) into the bucket.
8. Replace overflow drain (22).
9. Put the tile saw on the ground.
10. For lifting or transport, use the transport handle
(4).
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
WWW.VONROC.COM