Cannot Connect Via Bluetooth - EDIFIER MP100 Plus Manual

■ Specifications
Power output: 5W
Frequency response: 200Hz-18KHz
Input: 5V 1A
Note:
• Images are for illustrative purposes only and may differ from the actual product.
• For the need of technical improvement and system upgrade, information and
specifications contained herein may be slightly different from actual product. If any
difference is found, the actual product prevails.
■ Troubleshooting
No sound
• Check if the speaker is ON.
• Try to turn up the volume using the volume control.
• Ensure the audio cables are firmly connected and the input is set correctly on the
speaker.
• Check if there is a signal output from the audio source.

Cannot connect via Bluetooth

• Make sure the speaker is switched to Bluetooth input. If it is in other audio input
modes, Bluetooth will not connect. Disconnect from any Bluetooth device by
pressing and holding the "
• Effective Bluetooth transmission range is 10 meters; please ensure that operation
is within that range.
• Try another Bluetooth device for connection.
Noise coming from speakers
• EDIFIER speakers generate little noise, while the background noise of some audio
devices are too high. Please unplug audio cables and turn the volume up, if no
sound can be heard at 1 meter away from the speaker, then there is no problem
with this product.
To learn more about EDIFIER, please visit www.edifier.com
For EDIFIER warranty queries, please visit the relevant country page on
www.edifier.com and review the section titled Warranty Terms.
USA and Canada: service@edifier.ca
South America: Please visit www.edifier.com (English) or www.edifierla.com (Spanish/
Portuguese) for local contact information.
" button, then try again.