Commissioning/Decommissioning; Charging The Rechargeable Battery (09, 10); Determining The Charge Status Of The Rechargeable Battery (11) - AL-KO ST 4048 Manual De Instrucciones

Ocultar thumbs Ver también para ST 4048:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 61

Commissioning/Decommissioning

3. Place a washer (08/5) on each of the car-
riage bolts (08/c).
4. Screw star handles (08/6) onto the carriage
bolts and firmly tighten (08/c).
6 COMMISSIONING/DECOMMISSIONING
6.1

Charging the rechargeable battery (09, 10)

The rechargeable battery and the charging unit
are not included. The following li-ion recharge-
able batteries and charging units from AL-KO can
be used:
Product
Designation
Li-ion re-
B150 Li (B05-3640)
chargeable
battery
Li-ion re-
B200 Li (B05-3650)
chargeable
battery
Charging
C130 Li (C05-4230)
unit
The rechargeable battery is partially charged.
Fully charge the rechargeable battery before us-
ing it for the first time. The rechargeable battery
can be charged in any charge status. Interrupting
charging does not damage the rechargeable bat-
tery.
NOTE For detailed information, heed the
separate operating instructions for the recharge-
able battery and for the charging unit.
CAUTION! Danger of fire during
charging! Due to heating of the charger, there is
a danger of fire if it is placed on an inflammable
surface and is not adequately ventilated.
Always use the charger on a non-inflamma-
ble surface or in a non-combustible environ-
ment.
If available: Keep the ventilation slots free.
1. Insert the rechargeable battery (09/1) in the
charging unit (09/2) and plug the power plug
(09/3) into the power outlet. The charging
process begins and the LED for indicating the
operating status (09/4) flashes green.
2. Observe the LED (09/4). The charging pro-
cess takes approx. 1.5 hours until fully
charged. The charging process ends auto-
matically when the rechargeable battery is
fully charged. The LED (09/4) then lights per-
manently green.
469905_d
3. Disconnect the power plug (09/3) when the
LED (09/4) permanently lights green.
4. Press and hold the engaging button on the
bottom of the rechargeable battery.
5. Pull the rechargeable battery (09/1) out of the
charging unit (09/2).
Status displays on the charging unit (10)
The LED (10/1) on the charging unit indicates the
charge status of the rechargeable battery and the
operating condition of the charging unit. The sym-
bols (10/2) on the charging unit indicate these
states:
Item no.
Symbol LED and charge status
113280
113524
113281
6.2
Determining the charge status of the
rechargeable battery (11)
There is a control panel with a pushbutton (11/1)
and LED charge status displays (11/2 to 11/5) on
the front of the rechargeable battery.
1. Press the pushbutton (11/1). The charge sta-
tus displays light according to the charge sta-
tus of the rechargeable battery.
2. To read the charge status, see section
"Charge status displays on the rechargeable
battery".
Charge status displays on the rechargeable
battery
LEDs
Green
(11/2)
Green
(11/3, 11/4)
Green
(11/4)
LED lights green: The rechargeable
battery is fully charged.
LED flashes green: The recharge-
able battery is charging.
LED lights red: There is no recharge-
able battery in the charging unit.
LED flashes red: The rechargeable
battery is too hot and will therefore
not charge.
Battery charge level
Rechargeable battery is fully
charged, i.e. to 100%.
Rechargeable battery is charged
to over 50 %.
Rechargeable battery is charged
to less than 50 %.
27

Publicidad

Tabla de contenido
loading

Tabla de contenido