VONROC JR501DC Traducción Del Manual Original página 8

EN
18. Antenna tip
19. USB port cover
20. Battery LED indicators button
21. Battery LED indicators
22. Charger
23. Charger LED indicators
3. ASSEMBLY
The battery must be charged before fi rst use.
Inserting the battery into the machine (Fig. B)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (4) into the base of the
machine as shown in Fig. B.
2. Push the battery further down until it clicks into
place.
Removing the battery from the machine (Fig. B)
1. Push the battery unlock button (5).
2. Pull the battery out of the machine like shown
in Fig. B.
Checking the battery charging status (Fig. F)
• To check the battery charge status, push the
button (20) on battery shortly.
• The battery has 3 lights indicating the charge
level, the more lights that burn, the more charge
the battery has left.
• When the lights are not burning it means
the battery is empty and must be charged
immediately.
Charging the battery with the charger (Fig. F)
1. Take the battery (4) from the machine.
2. Turn the battery (4) to upside down position and
slide it onto the charger (22) as shown in Fig. F.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators on
the charger (23) will lighten up and show the
charger status.
8
Red LED Status Green LED status
Off Off
Off On
On Off
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the
charger plug from the outlet and remove the
battery from the charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
Setting the antenna (Fig. C)
• Point the antenna upwards.
• Take the tip (18) and pull it out to a total length
of 30cm, there are 5 sections.
• Point the antenna (17) toward the direction that
enables the best reception.
Tip! When the reception is insuffi cient,
position the radio at a different location that
enables better reception.
4. OPERATION
Place the product on an even surface to
prevent falling.
Turn on/ turn off (Fig. D)
• Hold the power button (7) for a few seconds to
turn on the radio. Until you hear "power on".
• Hold the power button (7) for a few seconds to
turn off the radio. Until you hear "power off".
Adjusting volume (Fig. D)
• Increase volume: press "+" button (13).
• Decrease volume: press "-" button (14).
Charger status
No power
Standby mode:
- No battery is
inserted or,
- Battery inserted
but charging has
fi nished
Battery charging in
progress
WWW.VONROC.COM