VONROC JR501DC Traducción Del Manual Original página 9

Choose audio source: FM-Radio or Bluetooth
streaming (Fig. D-E)
• Press the Mode button (8) to switch between
FM mode or Bluetooth mode.
• You will hear the mode selected and it will show
on the display, Bluetooth symbol (6A) or FM
symbol (6B).
FM-Radio mode - Searching for station (Fig. D)
Hold the ">" button (15) for a few seconds and the
radio will search for the fi rst available radio station
(higher frequency). For lower frequencies use the
"<" button (16).
Manually changing frequency (Fig. D-E)
Press the ">" or "<" button (15, 16) until you reach
the correct frequency.
FM-Radio storing stations (Fig. D-E)
Easily switch between your favorite radio stations
by using the pre-set 1 to 6. For this example we are
going to pre-set one station as pre-set number 3.
• Press button "1-6" (11) until 3 (6D) shows on
the display (6) like shown in fi gure D.
• Search for your favorite radio station by using
the search buttons (15, 16). FM frequency (6E)
will show in display (6).
• Hold the pre-set button (10) to save this
frequency as pre-set number 3, the number 3
will appear again on display (6D).
Bluetooth mode (Fig. D-F)
Connect for fi rst time
• Press the mode button (8) until you are in
Bluetooth mode.
• Turn on the Bluetooth on your mobile device.
• Scan for "VONROC Radio" on your mobile
device.
• Connect it to the radio. You will hear
"connected" and the Bluetooth symbol on the
radio will stop blinking.
Disconnect/Reconnecting
• Press the Bluetooth button (9) on the radio to
disconnect or unable the Bluetooth on your
mobile device. You will hear "disconnected"
and the Bluetooth symbol on the radio will start
blinking again.
WWW.VONROC.COM
• To reconnect make sure the Bluetooth on
your mobile device is turned on and press the
Bluetooth button (9). You will hear "connected"
and the Bluetooth symbol on the radio will stop
blinking.
When the radio is connected to the mobile device
you can control the volume either on the radio (by
using "+" or "-"buttons) or by mobile device. You
can also skip or go back a song by using the radio
(buttons "<" or ">") or by mobile device. Use the
play/pause button (12) to play or pause your song.
USB charging
• Insert a USB charging cable (not included) to
the USB port (3) on the back side of the radio
and the other end to your mobile device.
USB port can only be used for charging mobile
devices, it will not work as an MP3 player. After use
close the USB port cover (19) to prevent dust or dirt
to clock up the USB port.
Battery level
The battery symbol (6C) on the display (6) shows
the battery level of the battery.
Handle and mobile device stand
The radio should be transported using the handle
(2). The handle has a recess which can be used to
hold the mobile phone while in use.
WARNING: A mobile phone cannot be
secured in the recess/handle and can fall if
the radio is moved or transported. Be sure
to remove mobile phone from the recess/
handle before moving or transporting the
radio.
The hole in the handle can be use for the
charger cable to fi t inside the mobile device
while standing in the recess/handle.
5 MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
EN
9