Operation; Control Panel Operation; Menu Map; Configuration (Dmx) - Chauvet DJ SWARM WASH FX ILS Manual Del Usuario

Operation

4. Operation
This product is not designed for continual use. Make sure there are regular breaks during operation to
maximize the life of the lasers. Always disconnect the Swarm Wash FX ILS from power when not in use.

Control Panel Operation

To access the control panel functions, use the four buttons located underneath the display. Please refer to
the Product Overview to see the button locations on the control panel.
Button Function
<MENU> Selects an operation mode or backs out of the current menu option
<UP> Navigates upwards through the menu list or increases a selected numeric value
<DOWN> Navigates downwards through the menu list or decreases a selected numeric value
<ENTER> Enables the currently displayed menu or sets a selected value into the selected function

Menu Map

Refer to the Swarm Wash FX ILS product page on
Mode
2-Ch
DMX
18Ch
Automatic
P--
program
Program speed S--
Sound-active
Snd
program
ILS mode iLS
Infrared SEt

Configuration (DMX)

The Swarm Wash FX ILS works with a DMX controller. Information about DMX is in the CHAUVET DMX
Primer, which is available from the Chauvet website
DMX_Primer_rev05_WO.pdf.

DMX Personality and Starting Address

When selecting a starting DMX address, always consider the number of DMX channels the selected DMX
mode uses. If the starting address is set too high, access to some of the product's channels could be
restricted.
The Swarm Wash FX ILS uses up to 18 DMX channels in the 18Ch mode, which defines the highest
configurable address to 495.
The Swarm Wash FX ILS uses 2 DMX channels in the 2-Ch mode, which defines the highest configurable
address to 511.
For information about the DMX protocol, download the DMX Primer from www.chauvetdj.com.
To select the DMX personality and starting address, do the following:
1. Press <MENU> repeatedly until 2-Ch or 18Ch shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the starting address, from d 1–511.
4. Press <ENTER>.
The display will continue to blink until the fixture receives a DMX signal.
Swarm Wash FX ILS User Manual Rev. 5
www.chauvetdj.com
Programming Levels
d 1–511
d 1–495
FAdE
P 1–15
SnAP
S 1–99
Sn 1–15
iLS1–4
on
oFF
http://www.chauvetlighting.com/downloads/
for the latest menu map.
Description
4-channel DMX mode
18-channel DMX mode
Automatic programs (see Programs)
Automatic program speed
Sound-active programs (see Programs)
Sets ILS mode
Enables/disables infrared control
Page 12 of 125