Message List - Bayrol Automatic pH Instrucciones De Uso

Operation
14
Tap in the blue areas ...
Access codes
User Code Service Code
1234
Operating modes pH value
Auto
The Automatic
pH
in the pool.
Off
The automatic pH control is switched off.
Timer functions pH value
Fill and/or flush pump hoses
In the event that the pH dosing hose is empty (e.g. when changing canisters), you can start the pH-pump manually
here to fill the hose. Stop the process as soon as the dosing hose is completely filled (i.e. up to the injection valve).
Another menu helps you to rinse the dosing hose (e.g. when winterizing the tank).
Time limited dosage
The pH pump can be switched on for a selectable period of time. You can choose whether the pH dosing should stop
when the desired value is reached or only after the selected time has elapsed. You can stop the dosing manually at any
time.
Pausing the pH regulation
The automatic control of the pH value can be stopped for an adjustable period of time. After this pause, the previously
set regulation starts again automatically.
This mode can be advantageous, for example, when adding water care products manually.

Message list

All messages are listed in the message list. Additional in-
formation is displayed here for each message. In addition,
Automatic offers wizards for most messages that will
pH
guide you step by step to the solution.
If the issue cannot be solved despite following all the
instructions, please contact your dealer.
Calibration – adjustment of the measured pH value
Please note that when calibrating the pH sensor using the
enclosed buffer solutions, you must remove the sensor
from its holder. Make sure that not too much water can
leak out during this process.
Follow the instructions on the display.
5678
automatically doses pH-Minus Liquid Domestic (or pH-Plus Liquid) depending on the desired pH value
Status Icons pH
Operating mode
Indicator dosing pump pH
Fill level canister pH
(red, when empty)
RECOMMENDATION
To avoid taking out the sensors, you can perform the
calibration with the pool water.
Please measure the pH value with a photometer
(e.g. BAYROL Electronic Pooltester).
25