Remote Control Connection; Remote Control Pairing - LUMIT IMBAT Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTRUCTION MANUAL
IMBAT
REF. 202296302
8. Carefully place the receiver, transformer and all wires in the
ceiling cup. Do not bend or break the cables. Raise the ceiling cup to
the ceiling and tighten with the screw. Make sure it is well tight.

REMOTE CONTROL CONNECTION

_____________________________________________________________________________
Before making the electrical connections, confirm that the main
power source has been turned off. The fan does not have a speed
control switch, so it can only be controlled by the supplied radio
frequency command.
NOTE
_____________________________________________________________________________
Make sure the connections are made properly and according to the
correct wire colors (pair wires of the same color).
FAN AND LIGHTS
ALL OFF
ON/OFF
F
FAN DIRECTION:
CLOCKWISE
2
FAN
ON/OFF
SPEED
CONTROL
1
1H
1H
TIME
CONTROL

REMOTE CONTROL PAIRING

_____________________________________________________________________________
Turn off the power, wait 10 seconds, then turn it back on. At the
same time, press the "ALL OFF" button. If you hear a beep, it means
the code was successful.
TROUBLESHOOTING GUIDES
____________________________________________________________________________
1. When the remote does not control the fan (receiver), check that
the wiring connection is as per the diagram, that the positive and
negative poles are connected correctly and that the battery charge is
sufficient. If the battery voltage is too low, it will affect the trans-
mission intensity and may cause the remote control to fail. Please
replace the batteries in time.
2. When the remote does not control the fan, please check if there
are similar products nearby. Simultaneous transmission of radio
waves by remote control products may interfere with each other
and may affect the reception effect.
3. Battery charge will decrease over time. Please replace used batte-
ries to avoid damage to the transmitter and handle them correctly.
4. If you don't use the fan for a long period of time, please remove
the batteries from the remote.
[ EN ]
LIGHT
LIGHT
ON/OFF
ON/OFF
R
FAN DIRECTION:
COUNTER CLOCKWISE
3
4
FAN OFF
5
6
2H
4H
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

202296302

Tabla de contenido