AmazonBasics B01FV0FAL2 Guía De Bienvenida página 4

Operating Instructions
Step 1: Installing the batteries
1. Remove the battery cover on the back of the presenter.
2. Place two AAA batteries (included) in the battery compartment. Make sure
to match the + and - on the battery to the + and - signs in the battery
compartment.
Step 2: Connecting the presenter to the
computer
1. Remove the mini receiver from built-in storage located on the inside of the
battery cover and insert it into a USB port on the computer. The computer
system will automatically detect the receiver and install the new USB driver.
2. Power on the presenter by sliding the on/off switch to the ON position. When
the driver is installed, the computer will notify you that the device is connected
and ready to use.
Note: If you are having trouble connecting to your computer, follow the
troubleshooting steps below.
1. Remove the mini receiver from the USB port and turn off the presenter.
2. Re-insert the mini receiver into the USB port and place the presenter
within 20cm of the mini receiver. Press and hold the Play button while
turning on the presenter to establish a connection to your computer.
This process should be finished within 1 minute.
Step 3: How to Use with PowerPoint
1. Open a PowerPoint file.
2. Press the Play button to start the slideshow.
3. Use the Page Up button to advance to the next slide and the Page Down
button to return to the previous slide.
4. Control the volume by pressing the Vol+ button to increase and the Vol- button
to decrease.
5. Press the B button to blacken the screen and resume the presentation.
6. Press the Red Laser Pointer Key to activate the red laser beam.
7. Press the Esc button to exit the presentation.
4