Product Identification - MADER J0F-2ET-10.8 Manual Del Usuario

CHARGERS
1. Use your charger only to charge the battery in the tool which it was supplied. Other batteries
could burst, causing personal injury and damage.
2. Never attempt to charge non-rechargeable batteries.
3. Do not expose the charger to water.
4. Do not open the charger.
5. Do not probe the charger.

PRODUCT IDENTIFICATION

CONTENTS:
1.Blade 2. Head Protection 3. Power Head 4. Trigger Lockout 5. Trigger
6. Battery
RECHARGEABLE BATTERY
CHARGING BATTERY(Fig.1)
Before attempting to charge the battery pack, thoroughly read all Safety
Instructions.
The battery needs to be charged before first use and whenever it fails to produce
sufficient power on jobs that were easily done before.
The battery may become warm while charging; this is normal and does not
indicate a problem.
NOTE: After several charge and discharge cycles, the battery will attain full capacity.
DO NOT CHARGE THE BATTERY AT AMBIENT TEPERATURES BELOW 4ºC OR
ABOVE 40ºC BELOW 40ºF OR ABOVE 104ºF
（
.
）