Technical Data; Intended Use; Safety Informations - BGS technic 86690 Instrucciones De Uso

Universal cartridge soldering torch, with piezo ignition

TECHNICAL DATA

Power: 3500W
Gas consumption: 110 - 254 g/h
Flame temperature: 1300°C
Working temperature: 650°C
Gas type: Butan catridge 190 g (EN 417)
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.

INTENDED USE

This product is used to heat materials in well-ventilated areas or outdoors and works with 190g
butane cartridges, in accordance to EN417 standard.

SAFETY INFORMATIONS

Keep children and other persons away from the working area.
•
Do not allow children to play with this tool or its packaging.
•
• Do not use the tool if parts are missing or damaged.
Use the tool for the intended purpose only.
•
Use only the specified gas cartridges. Use of other gas cartridges can be dangerous.
•
• Do not tamper or modify this product.
Use this product only in a well-ventilated area or outdoors.
•
Place the product on firm, level surfaces only.
•
• The product must not be used near flammable materials or substances.
Replace the cartridge outdoors or in a well-ventilated area, away from hazardous sources such
•
as open flames, electric stovetops, and far away from other people or animals.
• To check that the device is leaktight, go outside and do not use a flame, but soapy water. Do
not use the device if the seal is damaged or old. Do not use the product if it is leaking,
damaged, or defective.
• Do not use the product if it malfunctions.
Always place the product far away from hot surfaces or other heat sources.
•
During use, the device reaches high temperatures in the vicinity of the burner. Do not touch the
•
device when it is hot. After turning off the device, wait a few minutes to ensure that you will not
be burned during transport.
Never point the device at people or animals.
•
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 86690
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed