camry Premium CR 4414 Manual De Uso página 8

5. Put the water tank lid (3) back into its place.
Setting up the brewing process:
1. After filling the water tank (3) with water.
2. Turn on the device by pressing the ON / OFF button (A2 B).
WARNING: DO NOT TURN ON THE DEVICE WITHOUT THE WATER TANK BEING IN PLACE. THE DEVICE EMITS STEAM AND
HOT WATER BACK INTO THE WATER TANK BEFORE STARTING.
3. The control panel will light up and begin to blink.
4. After the control panel stops blinking and shines in a stable light you can begin to prepare the brewing basket (5).
5. If a brewing basket (5) is already inserted in the device:
5a. Pull the lever (1) upwards to release the brewing basket (5).
5b. Remove the brewing basket (5).
6. If the brewing basket (5) is not inserted in the device:
6a. Pull the lever (1) upwards to prepare the device for the brewing basket (5).
Preparing the brewing basket (5):
1. Depending on the type of capsule or coffee powder choose the correct brewing basket (5).
2. There are 3 types of capsules.
A. Inserted from above. Dolce Gusto (J), Lavazza (L)
B. Inserted from below. Nespresso Capsule (I)
C. Inserted into the metal brewing compartment. Coffee Pod (K1) Coffee Powder (K2)
Depending on the type of capsule please follow the pictures F and G.
Picture F:
1. Pull on the inside of the brewing basket (5) and it will open up.
2. Insert the capsule into the hole in the brewing basket (5) so it is firmly nested inside and does not move.
3. Close the brewing basket (5).
NOTICE: The brewing basket (5) should shut completely and no part of the basket should stick out compared to the empty brewing
basket (5).
Picture G:
1. Push the capsule downwards into the brewing basket (5).
NOTICE: The brewing basket (5) should shut completely and no part of the basket should stick out compared to the empty brewing
basket (5).
For Coffee powder:
1. Please check picture H on page 4.
2. Pour the coffee powder into the brewing basket (5) metal adaptor. (Please note that the powder should not spill outside the metal
inlay.)
3. Push the coffee powder down making sure it is nice and flat and the adaptor can be closed without using too much strength.
For coffee pods:
1. Select the coffee powder brewing basket (5).
2. Insert the coffee pod adaptor into the brewing baskets.
3. Lay the coffee pod into the coffee pod adaptor.
Brewing:
1. Insert the previously prepared brewing basket (5) into the device.
2. Press the lever (1) down slowly but firmly.
WARNING: IF THE LEVER DOES NOT MOVE OR OFFERS MUCH RESISTANCE. DO NOT FORCE IT. REMOVE THE BREWING
BASKET (5) AND CHECK IF THE BREWING BASKET (5) IS CORRECTLY ASSEMBLED. OR IF THERE IS TOO MUCH COFFEE
POWDER INSIDE THE BREWING BASKET (5).
3. Check if the control panel is shining without any blinking.
4. If the control panel shows no problems press the desired option. Espresso(A2A) or Café Lungo (A2C).
5. The device will start to work. (PLEASE NOTE THE DEVICE WILL DISCHARGE ANY REMAINING WATER FROM THE BREWING
TANK BACK INTO THE WATER TANK.)
6. After finishing it will emit 2 sound chimes and will stop working.
7. It will be on standby for around 15 minutes.
8. After that time it will turn off.
You can also always cancel the brewing by pressing the ON / OFF (A2B) button.
9. Pull on the lever (1) upwards to release the brewing basket (5).
8