camry Premium CR 4414 Manual De Uso página 9

10. WARNING. AFTER BREWING THE BREWING BASKET (5) WILL BE HOT TO THE TOUCH. PLEASE TAKE CARE NOT TO BURN
YOURSELF.
11. Remove the capsule / pod / coffee powder from the brewing basket (5).
12. Rinse with water until fully clean.
13. Please make sure to drain the detachable drip tray and rinse it with water.
If you want to add some more water or think the amount of coffee is too little you can press and hold the espresso button and the device
will continue to produce water. TO stop releasing the button.
You can change the standby mode on or off.
Disable or enable the standby mode:
1. With the device unplugged from the mains power press both the Espresso (A2A) and Lungo (A2C) buttons.
2. Press the espresso (A2A) button to turn the standby mode On (light on) or Off (light turned off).
3. Press the ON / Off (A2B) button to confirm the setting.
Decalcification:
At least once a month or earlier depending on the number of drinks made the device needs to be decalcified.
To do so please follow the below instructions:
PLEASE NOTE: NEVER USE VINEGAR OR OTHER ACID-BASED DECALCIFIERS FOR THIS DEVICE. IT CAN DAMAGE THE
DEVICE.
1. Use specially made pressure coffee maker decalcifiers.
2. Fill the tank full with the solution of the decalcifier and water as per producers of the decalcifier guidelines.
3. Put a brewing basket (5) into the device and lower the lever (1).
4. Turn on the device.
5. Put a big bowl in place of the cup.
6. Please use the Lungo setting (A2C) and empty at least 2 full tanks of the decalcifier and water solution.
7. After the second tank of the solution is emptied. Please put fresh water into the tank and flush out the solution by emptying the fresh
water tank by pressing the lungo button until the tank is empty.
Device Data:
Voltage: 230V ~ 50Hz
Power: 1450 W
Maximum Power: 3000 W
Water capacity: 0,6 L
Please transfer cardboard packaging to waste paper. Pour the polyethylene bags (PE) into the plastic container
Worn device should be returned to the appropriate point storage because it is dangerous in the device
ingredients may pose a threat to the environment. The electrical device should be handed over to limit
its reuse and use. If in the device there are batteries you have to take out and give to the point stored separately.
9