ECRON WK8283B Manual De Usuario página 9

14. The kettle will switch off automatically when the
water has boiled. If you want to stop the heating
process before the kettle automatically switches off,
press the ON/OFF switch up.
15. After the kettle has switched off automatically (or
has been switched off manually) it may need time to
cool down. After 15-20 seconds, the kettle can be
switched on again.
16. The kettle is designed to disconnect the live electrical
supply from the element abnormal operating
conditions. If the water kettle is accidentally switched
on without water, the boil dry protector will operate.
17. If the kettle ever boils dry, the power indicator will
go out. Allow 15 minutes to cool before refilling with
cold water. The safety cutout will automatically reset
during this time.
18. Place the kettle on a stable flat surface.
19. Do not use this appliance outdoors.
20. Ensure that the kettle is switched off before
removing it from its base.
21. Do not remove the kettle from its base during
operation.
22. To protect against fire, electric shock and injury to
persons do not immerse cord, plug, power base or
16
the appliance in water or other liquid
23. Prevent children from pulling on the mains cord or
knocking the kettle over.
24. Ensure that the mains lead does not overhang the
worktop surface.
25. Always grap the kettle by the handle. The outside
surface of the kettle may get hot during use, please
take care when using the kettle.
26. Never fill in water more than the maximum
acceptable water level. Do not allow liquid to
penetrate the electrical parts of this kettle.
27. Never use the kettle with the lid open.
28. WARNING! Do not open the lid when steam is
coming out of the spout.
29. Before cleaning the kettle disconnect from the power
supply, wait until it was cooled down and separate it
from the base.
30. Use the appliance according to this instruction, any
misuse may cause electric shock or other hazards.
31. Regarding the instructions for cleaning surfaces
in contact with food, thanks to refer to the below
paragraph "Cleaning and Descaling" in manual.
32. Avoid spillage on the connector.
33. Heating element surface is subject to residual heat
after use.
EN
17