WARNING!
It is forbidden to insert the plug into multiple sockets and to use extension cord. (Picture
9)
There is no separate on-off switch on your product.
Do not contact the cables of your product, which are connected to the mains, to hot
surfaces.
The outlet you will use must be grounded.
Mains voltage and frequency must be same with the value written on the label inside
your product. If your mains voltage is extremely below or above the value indicated,
definitely supply demanded voltage by using a voltage regulator. You can get
assistance from an expert electrician with this regard.
Do not place your product's cord onto passageways. This may cause you to get injured
and damage your cooler (Picture 10).
PRODUCT USE
WARNING!
This operating manual applies for various device models. Hardware scopes of the
models may vary. There may be differences in the pictures.
Clean inside and all accessories of your product before the first use.
If your product has been shaken so much during the transportation and positioning,
wait for one hour without running it. Thus, the compressor oil, which may enter into the
system, will return back. You may damage the compressor if you run it without
considering this.
Insert your product's plug into an outlet with alternative current of 230V~50Hz only,
which has been installed according to the regulations. (Picture 11)
You will hear a slight sound from the compressor when your product is running.
The fan inside your product will stop once you open the door of your cabinet.
51