Jocel JEXC-014566 Manual De Instrucciones página 54

Do not load your product with food over the loading line, according the table below:
MODEL
Beverage Cooler JEXC-014566
DEFROSTING
Your product can be defrosted, manually.
If there is excessive ice on the shelves of your device, this will lead decrease in the
cooling capacity and increase in energy consumption.
If the ice is too thick, place the products inside of your device to another suitable
environment that prevents them to get spoiled.
Unplug your product. The ice generally melts in two hours.
Remove the cover from the drain hole, located on the lower front
Place a container on the bottom, for preventing the melted ice waters to damage the
floor. Place the drain hole cover.
After defrosting operation, wipe internal walls with a dry cloth to make sure that they
are not wet.
Run your device empty again for three hours and wait for it to cool down. Then you can
place your foodstuff in it.
TURN OFF
Transfer the foodstuff inside your product to a convenient place.
Unplug your product. (Picture 14)
If your product will not be used for a long time, apply following considerations:
Clean your product. Otherwise, the humidity on the wall may cause darkening of the
−
internal surface.
MAX.SHELF CARRYING CAPACITY
PICTURE 14
53
16 kg.