Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Instruction manual
•
First insert the left side with the L marking ( image 2; number 1) of the
rotating basket into the cooking space. To do this, plug the left end of
the shaft as far as it will go into the round holder on the left side of the
cooking space. Turn the basket until it is fixated into the axis and
cannot move.
•
Then hang the right end of the shaft into the support on the right side
of the cooking space. ( image 2; number 1)
•
Check if it is placed correctly.
•
Always use the removal handle to remove the rotating basket from the
cooking space (see removal tool chapter). The basket will be very hot.
•
If the handle holder is not accessible, the basket can be turned to the
correct position by pressing the
push two times to rotate to the other side.
Baking racks
•
The baking racks are slid onto the rails in the cooking space.
•
The heating element is located at the top of the cooking space.
•
The higher a rack is placed, the more intense the heat is from above.
•
In the upper part, the food is cooked faster and crispy.
6
button. Push one time to rotate,
•
The middle position can be selected to achieve uniform heating from
all sides.
•
The bottom rails are suitable for gentle cooking.
•
Use gloves to remove the baking racks.
USE
•
Put the mains plug in an earthed wall socket.
•
Open the door.
•
If the fat collecting tray is not to be used as a baking tray, slide it into
the lowest rails of the cooking space
•
Select a suitable accessory for the food to be prepared.
•
Process the food and place it on or in the accessory and attach this
accessory in the device.
•
Close the door.
•
Press the on/off switch. The display will become active.
•
Set the temperature and cooking time manually or choose between
one of the 10 programs.
Manual setting:
•
Touch the up or down symbol at the temperature setting to set the
desired temperature (lowest 65°C, highest 200°C).
•
Touch the up and down symbol at the time setting to set the desired
time(1 minute to 60 minutes).
•
Note: It is not necessary to preheat the device.
Program setting:
•
Activate the desired program by touching the program symbol, it's
activated when the symbol starts flashing.
•
Touching the same symbol again will cancel the selection.
•
See for presetting information the table below:
Publicidad
Tabla de contenido
