Natural Gas - Mx Onda MX-PG2204X Manual De Usuario E Instalacion

Gas supply connection via rigid tube
The gas outlet must have a key to be able to cut off the gas supply to the hob,
if you need to use the elbow adapter remember to insert the sealing gaskets.
Once the installation is complete, check that there are no gas leaks.
Electric connection
Connect the plug to a 220/240 V ~ 50 Hz mains socket that is equipped with an
earth connection. Route the power cord so that it does not touch any surface
that can become hot (the chassis of an oven, for example).
CHANGING THE TYPE OF GAS ON THE PLATE
The gas hob comes from the factory with injectors for BUTANE GAS
(G30), if you want to change it to NATURAL GAS (G20) you must use the
injectors supplied in the accessories bag.
The injectors are marked with the diameter of the gas outlet orifice, and it is
very important that you pay close attention when placing them, because if you
get confused you may have a very large flame on the small burner or a very
small flame on the smaller burner. the big burner.
Install the injectors as indicated in the following table:
Burner size
Auxiliary (small)
Semi fast (medium)
Fast (large)
Supply pressure

NATURAL GAS

(G20/25)
Injertor mark
70
92
110
20 - 25 mbar
13
BUTANE GAS (G30/31)
Injertor mark
50
65
85
28 - 37 mbar