Using The Appliance - Fagor 3FS-86314IT Manual De Instrucciones

USING THE APPLIANCE

Select Programme
1
Set the programme selector turning it left or right.
Customize the programme to your needs – you can change the
temperature, spin speed, or enable additional features.
Press the Start/ Pause button.
Time Remaining
2
To set the Time Remaining:
Close the appliance door.
Set the programme selector dial to the desired programme (see table).
Select additional functions or wash cycle parameters as required –
depending on the needs,
Press the Time Remaining button.
Select time remaining ranging from 0 to 24 hours.
Press the Start/ Pause button The appliance will be set in delay mode.
The wash programme will be automatically terminated.
When you set the Time Remaining option, the display will show the time remaining to the
end of the programme.
End of the wash cycle
3
The end of the wash programme is indicated by "End" in the
display and a sound signal (if this function is active).
Close the water valve.
Switch the washing machine off with the Standby button.
Disconnect the washing machine from the power supply.
Open the door and remove laundry.
Aborting and changing the wash programme
4
In order to abort a wash programme, push the Standby button.
Then switch the washing machine on again, select the required wash programme
and push the Start/Pause
Display energy-saving mode
5
About 10 minutes after the end of the wash programme, the display switches to the
energy-saving mode (instead of "End", "
The energy-saving mode remains active also, if within 10 minutes after the washing
machine was switched on with the Standby button, the selector dial is not turned and
no button is pushed.
button.
" now blink in the display).
101