Lionelo Astrid Manual De Usuario página 13

To loosen the belts, press the adjustment belt (N) and pull the shoulder belts
(C). Do not pull the belt protective cushion (fig. 10)
To tighten the belts, pull the harness adjustment belt (F) (fig. 11).
•
Belts height
When your child grows up, you can change the height of shoulder belts so that
they are best adapted to the size of your child. To do so, detach the belts from the
metal buckle at the back of the carrier (G in the fig. 13). Pull the belts through the
hole above (H in the fig. 13). Next fasten them again in the buckle. The shoulder
belt should be positioned at the height of child's arms or just below it (fig. 13).
•
Assembly / disassembly
To disassemble the belts, undo them and extend as much as possible (fig. 14). Next
detach the belts from the metal buckle at the back of the carrier (shoulder belts, fig.
13) and from the bottom (crotch belt). Pull the belts through holes and take them out.
To assemble the belts, pull them through holes and take them out at the back
and bottom of the carrier. Put the belts on the buckle (fig. 15).The ready belts
must not be twisted or tangled.
How to secure the child with carrier's safety belts
•
Loosen the belts – press the adjustment button (N) and pull the shoulder belts (C).
•
Press the red button on the buckle (D) (fig. 17).
•
Undo the belts and put them sideways.
•
Put the child into the carrier.
•
Pull the child's hands through shoulder belts (fig. 16).
•
Join shoulder belts (1 in fig. 18) and then insert them in the belt buckle (2 in fig. 18).
If the belts have been joined properly, you will hear a "click".
•
Pull the harness adjustment belt (F) and tighten the belts (fig. 18).
Note! The belts must not be twisted or tangled. The belts must not be loose,
must fit the child's body but must not cause any discomfort. There should be
sufficient space (two fingers wide) between the child's chest and safety belts.
How to install in the car
•
Change the position of the handle into C position (fig. 7).
‑ 13 ‑ EN