•
Place the carrier on the vehicle's rear seat in a rear-facing position (fig. 21).
Remember that it is forbidden to install the carrier on the seat equipped
with a front airbag.
In special cases it is allowed to install the carrier on the passenger's front seat, see:
How to use in the car.
•
Fasten the car safety seat and put the lap belt on the carrier. After fastening,
pull the lap belt through the carrier guide (K), as presented in the fig. 20.
•
Extend and pull the car shoulder belt around the carrier (fig. 23).
•
The belt must go through the rear guide (O). Belts must not be twisted.
After you have finished the procedure, push the carrier towards the seat
backrest. Tighten the car safety belts so that the carrier is stable.
Note! Before you hit the road, always make sure the belt goes through the guides.
The child restraint system must be placed on the central part of the seat. Do not
position the carrier too close to the belt buckle (fig. 24, 25).
How to disassemble the sunshade and covering
•
Sunshade
Change the position of the handle into C position (fig. 7).
Remove the sunshade from the carrier's casing (fig. 26), next find sunshade
fasteners at the bottom of the handle and slide them down (fig. 27). Pull
the bracket tabs out of the handles on the sides of carrier's casing. Pull the
sunshade from the carrier's casing (Fig. 26), then locate the rubber brackets
of the sunshade, attached to the plastic tabs of the cover. Slide the rubber
brackets off. (fig. 27). Put the plastic hooks of the cover back.
•
Covering
Press the red button on the buckle (D) and undo the carrier safety belts (fig.
28). Remove the belt covers (fig. 29). Remove the seat liner (fig. 30). Set the
handle in the C position (fig. 7). Slide both belt guides (K) by moving them
towards the back of the carrier. Find the covering fasteners and detach them
from the frame as showed in figure 27. Detach clips marked as O and remove
the covering on both sides in accordance with the arrow in fig. 31.
EN
‑ 14 ‑