the instructions provided in the manufacturer's instructions.
• The plastic parts of this car seat may heat up in the sun and cause burns on
the baby's skin.
• Protect the seat from the sun. Otherwise, the seat may be too hot for your child's skin.
• Never leave your child unattended in the restraint.
• Luggage and other objects that can cause injury in the event of a collision
should be properly secured.
• A child restraint system without upholstery should not be used. It is not
allowed to replace the seat upholstery other than that recommended by the
manufacturer, as it is an integral part of the device that affects its functioning.
• Keep the seat user manual when using the device. Keep it in the car where
the car seat is installed.
• Do not use load bearing points of contact other than those described in the
instructions and marked on the child restraint.
• If in doubt about the position of the adult seat belt buckle relative to the main
load-bearing points, contact the child restraint system manufacturer.
4. Set (fig. 2)
A.
handle
B.
back
C.
seatbelts
D.
safety lock
E.
cover
5. Usage
5.1 Shoulder straps height adjustment
The shoulder straps should be placed as close to the baby's shoulders as possible.
If the position of the straps is incorrect, remove them and install at a suitable
height (fig. 3).
1 - to low
5.2 Straps usage / adjustment
If the position of the safety straps is not suitable for your child, please complete
the following steps:
Step 1: loosen the shoulder straps.
F.
G.
H.
I.
2 - to high
‑ 7 ‑
seatbelts adiustment strap
strap holes
belts guide
lap strap
3 - correct
EN