Lionelo Noa Plus Manual De Usuario página 9

in the vehicle's safety buckle. Pull the belt to make sure it is properly secured in
the buckle (fig. 8b).
Step 3: Hook the shoulder part of the belt in the guide located at the rear side
of the baby seat's back (fig. 9).
Step 4: Tighten the 3-point seat belt by pulling it as it is shown in the picture
(fig. 10a).
After all these steps the baby seat is properly installed and secured (fig. 10b).
Make sure that the belt hasn't twisted during the installation and it is properly
tightened.
To remove the baby seat from the car, please follow the above steps in reverse
order.
5.4 Changing the handle's position
The seat's handle can be placed in 4 different positions. In order to change the
position, press the red buttons at the both sides of the baby seat simultaneously.
The buttons are located in the side corners of the baby seat (fig. 11, 12).
You can place the handle in 4 different positions:
1.
It is the only position you can use while mounting the baby seat on a vehicle's
seat.
2.
Basic position - you can choose it to carry a child.
3.
Resting position - use it to freely put a child in/out of the baby seat.
4.
Base position - ideal when you feed or play with a child.
Each time you change the handle's position make sure it has been properly
secured (locked).
5.5 Using the hood (fig. 13)
The handles at the ends of the frame are adjustable. "Click" sounds indicate that
the hood has been properly folded / unfolded.
5.6 Maintenance
The cover can be easily removed for cleaning. In order to do so, first pull the
straps out of the baby seat. Then remove the cover.
Cleaning: Straps and plastic parts can be cleaned with mild detergents and warm
‑ 9 ‑ EN