Replacing The Filter Cartridge; Maintenance; Specifications - cleansui AJP407-D Manual De Instrucciones

4 Pouring
Clean the pitcher, funnel and lid periodically. Wash the pitcher, funnel and lid with a
clean sponge and neutral kitchen detergent. Rinse thoroughly.
5. Replacing the Filter Cartridge (ACPC5-D)
Pull upward to detach filter cartridge.
Insert new filter cartridge and press into position. Follow installation instructions (pg.7)
The filter cartridge replacement period is approximately 3 months, however, this period may vary based
on the amount of water used, water quality and the temperature of water filtered (colder water needs
longer filtering). In general, use your filter counter as a guide for replacement, but earlier replacement
is recommended in the following circumstances:
• When the odor or taste of chlorine is detected
• If the unit has not been used for a long period of time

6. Maintenance

Clean the pitcher, the funnel and the lid periodically.
● Wash with a clean sponge and neutral kitchen detergent, and then rinse off thoroughly. Failure to rinse
thoroughly may result in cracks or deteriorated water quality.
Store in the
refrigerator
Pour
8

7. Specifications

Product Name
Model number
Material
Filter components
Working Pressure (min/max)
Capacity
Service flow rate
Filtered water temperature (min/max)
Electrical requirements
Replacement cartridge
AJP407-D Performance Data Sheet
Cleansui Reduction Data
Substance Overall persentage reduction
NSF/ANSI Standard 42 - Aesthetic Effects
Chlorine 97.1 %
Maintenance according to the manufacturer's instructions is critical for proper filter performance. Filter life
should not exceed 26.4 gallons. If filtering time is notably increased, replace the cartridge earlier.
This system has been tested according to NSF/ANSI standard 42 standards by NSF International for reduction
of the substances listed above. The concentration of the indicated substances in water entering the system
was reduced less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI
standard 42.
The system conforms to NSF/ANSI standard 42 for specific performance claims as verified and substantiated
by test data. While testing was performed under standard laboratory conditions, actual performance may vary.
The use of this system need comply with applicable state and local laws.
Water Filtration Pitcher
AJP407-D
Body: SAN (AS)
Cartridge: ABS
Lid: PP, ABS
Funnel: MBS
Hollow fiber membrane, Activated carbon, Ion exchanger
Atmospheric
26.4gallons (100L)
0.1L/min
33°F/95°F (1°C/35°C)
none
ACP5-D
NSF/ANSI Standard Requirements
Reduction requirement /
Influent challenge
Maximum permissible product
concentration
water concentration
≧ 50 %
2.0 mg/L ± 10 %
9