Gude 40039 Traducción Del Manual Original página 12

pneumatic oil to the air inlet. Then, refit the air hose and let
the impact wrench run for app. 30 seconds to allow the
compressor engine to clean out. After cleaning, follow the
lubrication instructions.
Troubleshooting
Problem Possible cause
No power Too small amount of
air (see Technical
specifications)
Impact Insufficient air pressure Check the air pressure
wrench not
working or
working
Air pressure set too
too slow
low
Impact wrench must be
lubricated with oil
Impact wrench must be
cleaned out
Air hose is leaking
Problem solution
Bigger compressor
on the air inlet. It must
be 6 bar.
Increase the pressure
to 6 bar
See Lubrication
See Servicing
Tighten all the hose
screwing
12