Assembling; Operation - CASO DESIGN UZ 400 Manual Del Usuario

15.3 Assembling

Place the antislip-ring on a stable surface. Place the glass bowl on the antislip-ring.
Touch the blased exclusively at the drive shaft and carefully remove the protection caps.
Place the blades on the holder in the glass bowl.
Add your desired food. Put the lid on the glass bowl. Place the motor unit onto the drive
shaft and push it down until it latches..

15.4 Operation

Place the blades on the holder in the glass bowl. Add your desired food.
Put the lid on the glass bowl.
Place the motor unit oto the drive shaft and push it down until it latches..
Use speed 1 or 2, depending on your selected food.
Speed 1 – soft fruit and vegetables for example: onions, garlic
Speed 2 – hard fruits (without seeds), hard vegetables (such as carrots), meat
Food
Pork, poultry, beef
Garlic, hot peppers,
carrots, apples, herbs for
example parsley
► Do not place more as 400 g food into the glass bowl.
► Do not grind nutmegs, black pepper or similar, dry bread, gristles or stones.
► Do not grind meat with bones or bones.
► Run the device in intervals of 30 seconds of operation, 2minute cool down time
► After 3 intervalls let the device cool down for 30 minutes.
► The glass bowl is designed for 0 - 50 ° C. Do not put the glass bowl in the microwave
and do not fill food in it that is colder than 0 ° C or hotter than 50 ° C.
► Always check that the blades are correctly placed before starting the device.
Otherwise disconnect the power plug and assemble the device correctly.
Maximum
amount
400 g, cut in
pieces of approx.
2 x 2 x 5 cm
300 g
Please note
Processing time
Until the desired
consistency is
reached
Until the desired
consistency is
reached
Note
Remove tendon,
bones, skin
34