Troubleshooting; Safety Notices - CASO DESIGN UZ 400 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 69
Glass bowl and blades
Fill the glass bowl with lukewarm water until the lowest blade is just covered and add a
drop of mild detergent. Operate the device at level 1 for 10 seconds.
Disconnect the power plug and remove the motor unit.
Clean the lid and glass bowl under running water and dry thoroughly.
Touch the blades at the drive shaft and clean the blades under running water. Afterwards,
keep the blades out of the reach of children and let them dry thoroughly.
Reassemble the devic and store it in its carton.
► Do not add more water or detergent as descrbied as the mixture may overflow.
Attention
► The blades are very sharp, touch them exclusively at the drive shaft.
► Be careful with them. Carefully place the protection caps and store the device only
with the protection caps placed on the blades.
► Never leave the blades in soapy water so that they float "invisibly" in the water.
► Dry all parts before reusing or storing them. Store the parts, as well as sharp knives,
out of the reach of children.

17 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages.

17.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
Problem
The device is not working
after pressing a button.
The device stops durings
use.
The device vibrates
abnormally or is louder than
usual.
Please note
Cause
The device is not
assembled correctly.
The device was operated
too long or was overloaded.
The device is not
assembled correctly or is
places uneven. The device
is overloaded.
Solution
Check the assembling of
the device.
Pull the mains plug and let
the device cool down for at
least 30 minutes. Cool your
food during this time,
remove some food.
Check the assembling of
the device. Place the device
on a stable surface. Unplug
the mains plug and remove
some food.
36

Publicidad

Tabla de contenido
loading

Productos relacionados para CASO DESIGN UZ 400

Este manual también es adecuado para:

1748

Tabla de contenido