Important Safety Instructions; Equipment Connection - Tripp-Lite Power It! Manual Del Propietário

Important Safety Instructions

SAVE THESE INSTRUCTIONS
• DO NOT connect the power strip to an ungrounded outlet.
• DO NOT use the power strip with 2-wire extension cords or adapters.
• This power strip is designed for indoor use only. Install the power strip
away from heat-emitting appliances such as radiators or heat registers.
• Do not install where excessive moisture is present.
• Do not plug extension cords into the power strip.
• Never install electrical, telephone, network or coaxial wiring during a
lightning storm.
• Do not drill into any part of the housing or open the housing for any
reason. There are no user-serviceable parts inside.
• Use of this equipment in life support applications where failure of this
equipment can reasonably be expected to cause the failure of the life
support equipment or to significantly affect its safety or effectiveness is
not recommended.

Equipment Connection

Plug your equipment into the Power Strip's AC receptacles. DO NOT
plug in equipment that draws more total amps than your Power Strip's
amperage rating (see label on Power Strip for amperage rating), or you
will trip the circuit breaker. If the circuit breaker trips, remove overload
and depress breaker to reset. Leave enough clearance at the end of the
Power Strip to allow the circuit breaker to operate normally.
Note: Select models with a power switch feature a protective switch cover. To
access the switch, flip open the attached cover.
2