Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT SPECIFICATION
Voltage
Frequency
120 V~
Note: Tolerances on all specification: +5%, -10%
INSTALLATION INSTRUCTIONS
1. Pass the power cord down the "Power Cord Channel" between the "Right" and "Left"
Pillars, snap the "Right" and "Left" pillar together.
2. Place the pillar assembly onto the bottom of the" Main Body". Using a Phillips
crosshead screw-driver, insert the four screws provided through the top
of the assembly and into the "Main Body". Now tighten the screws down.
3. Run power cord through central opening in Base Assembly. Secure "Power Cord" in
"Power Cord Carriage" on the base.
4. Snap "Right Base" and "Left Base" together and fasten in place using the three
screws provided.
5. Place Base Assembly onto the bottom of the Pillar Assembly and fasten in place
using four screws.
CAUTION- Risk of fire-Do not operate without base attached.
CAUTION - Operate the heater in upright position only (controls on the top). Any other
position could create a hazardous situation.
Main body
Right Pillar
Right Pillar
Wattage (Max)
60 Hz
Left Pillar
Power Cord
Channel
1500W
Power Cord
Carriage
Figure B
E-4
Max. Amperage
12.5 A
Center
Opening
Power Cord
Carriage
Screw x 5
Publicidad
Tabla de contenido
