Model/型號/型号:
MN: CP001
MN: CP001WA
Frequency & TX Power Information
Rating/額定電壓電流/额定电压电流
Input: 5 V
500 mA Max
Battery Information
Contains 3.7V, 600mAh Li-ion Battery, 2.22Wh
Input: 5 V
500 mA Max
Cannot be replaced by user
Frequency & TX Power Information
Frequency Bands: 2.4Ghz
Controller (TX Power 2.4G/ BT: <5.5dBm / Class 2)
Wireless Adapter (TX Power 2.4G: <5 dBm)
FCC Compliance and Advisory Statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, according to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation.
This equipment generates, uses and can radiate radio frequency energy and
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment o and on, the useris
encouraged to try correct the interference by one or more of the following
measures:
1. Reorient the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into and outlet on a circuit di erent from that to
which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Any special accessories needed for compliance must be speci ed in the
instruction manual.
Warning:
A shielded-type power cord is required in order to meet FCC emission
limits and also to prevent interference to the nearby radio and television
reception. It is essential that only the supplied power cord be used. Use
only shielded cables to connect I/O devices to this equipment.
CAUTION:
Any changes or modi cations not expressly approved by the party
responsible for compliance could void your authority to operate the
equipment.
Canada Notices
This Class B digital apparatus complies with Canadian ICES-003.
Avis Canadian
Cet appareil numérique de la classe B est conforme à la norme NMB-003
du Canada.
ISED Statement:
This device contains licence-exempt transmitter(s) that comply with
Innovation, Science and Economic Development Canada's licence-ex-
empt RSS(s). Operation is subject to the following two conditions:
(1) this device may not cause interference,
(2) this device must accept any interference, including interference that
may cause undesired operation of the device.
L'émetteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d'Innovation, Sciences et Développement
économique Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
(1) L'appareil ne doit pas produire de brouillage;
(2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
NCC Statement:
取得審驗證明之低功率射頻器材,非經核准,公司、商號或使用者均不得擅
自變更頻率、加大功率或變更原設計之特性及功能。低功率射頻器材之使用
不得影響 飛航安全及干擾合法通信;經發現有干擾現象時,應立即停用,並
改善至無干擾
時方得繼續使用。前述合法通信,指依電信管理法規定作業
之無線電通信。低功
率射頻器材須忍受合法通信或工業、科學及醫療用電
波輻射性電機設備之干擾。
Japan VCCI JRF Statement:
Class B ITE
この装置は、情報処理装置等電波障害自主規制協議会(VCCI)クラ
スB情報技術装置です。この装置は、家庭環境で使用することを目的と
していますが、この装置がラジオやテレビジョン受信機に近接して使用
されると、受信障害を引き起こすことがあります。
取扱説明書に従って正しい取り扱いをして下さい。