Uline H-9980 Manual Del Usuario página 2

CEILING OR SIDE MOUNTING
1. Open EXIT panel from the housing and remove the
hole plugs from the top (or side) of the housing, if
necessary. (See Figure 2)
Figure 2
Hole Plugs
EXIT Panel
2. Carefully remove the proper directional chevron(s)
from the EXIT panel(s) if necessary. (See Figure 3)
Figure 3
PAGE 2 OF 9
INSTALLATION
Housing
Hole
Plugs
3. Secure canopy to the housing with two #10-24
CAUTION! Carefully remove the knockouts from
back plate. Otherwise, it may cause damage
on the surface. (See Figure 4)
Figure 4
screws (provided) using hole numbers 2 and 3
labeled on canopy. (See Figure 5)
NOTE: Figure 5 shows ceiling mounted setup.
Figure 5
Hole #2
Housing
Back Plate
Hole #3
Canopy
0222 IH-9980